Joye eGo ONE V2 Starter Kit
Petite yet powerful, the eGo ONE V2 is the One device for everyone. The eGo ONE V2 is petite in appearance, as long as a real cigarette, but is powerful enough to produce vaporing cloud. The eGo ONE V2 is 510 threaded and has a adjustable airflow valve. Rotate the ring on the atomizer base clockwise to decrease the air inflow, and counterclockwise to enlarge the air inflow. The eGo One V2 kit has two drip tips included, a metal and glass version with thermal insulation. The Ego One V2 kit features a built in 1500mAh battery that can be charged via the micro USB charging port.
The Primary Features of The eGo ONE
Passthrough: The eGo ONE is charged through a Micro USB Port via a computer or a wall adapter with the USB cable. It can also work as a pass-through device for simultaneous vaping and charging. The battery must contain a small charge before it can be used in this way. If you're using the battery quicker than it can charge, the battery will shutoff. We suggest charging the battery for 10-15 minutes before using it.
ON/OFF battery switch: Press the power button five times in rapid succession to turn on the eGo ONE. Once the eGo ONE is on, hold down the power button to activate the atomizer and vape. When the eGo ONE is not in use, press the power button five times in succession to power off the device. Always power off the eGo ONE when it is not being used, or when it is going to be stored in a pocket, bag or purse.
Battery capacity: The eGo ONE has a built-in mAh polymer Li-Ion rechargeable battery available in 1500 mAh
15 second cutoff: If the activation button is held for 15 seconds or longer the device will stop firing until the button is released and pressed again.
Low voltage warning: The indicator light will continue blinking when the battery capacity is lower than 3.3V and the device will power off automatically.
Short circuit protection: Short circuit protection protects the device against shorted atomizers and will stop the unit from functioning in unsafe conditions.
Battery display function: The light indicator will flash slowly or stay lit when battery level is high, and the light will flash with frequency if low.
Battery quantity Light condition 60% - 100% Stay lit 30% - 59% Slowly flashes 10% - 29% Moderately flashes 0 - 9% Flashes in frequency
The battery light flashes red when charging or connecting with USB, and goes out in 5 seconds when it is fully charged.
Specifications:
- 510 Threaded
- 2.0ml Capacity Tank
- Operating Voltage: 3.3 - 4.2 V
- Stainless steel construction
- Available in 1100 mAh or 2200 mAh
- Adjustable airflow control valve
- Low voltage protection
- Short circuit protection
- Minimum Resistance: 0.5 ohms
- Dimensions:4-1/4" x 3/4"D (Including Drip Tip)
Compatible Coils:
myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a LI-ION battery. Please have a basic understanding of the batteries you are using and how to care for them properly.
Tips for new nicotine users: Sub-ohm or low resistance atomizers produce a higher throat hit than standard,high resistance atomizers. We strongly suggest 3 to 6mg eLiquid or lower with sub-ohm or low resistance atomizer heads. Preference may vary depending on the user and frequency of use.
For standard,high resistance atomizers or restrictive devices (ex. pod based,pen), we recommend 6mg or higher due to the mouth to lung (MTL) design of this atomizer,tank. Preference may vary depending on the user and frequency of use.
Warning: Sub ohm or low resistance tanks should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 20 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.
Battery Safety Warning:
Use special caution when using Li-Ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure you have enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use.
Do not let your batteries come into contact with metal objects such as keys, loose change or any other metal objects. Doing so will put you at risk for short circuiting your battery and explosion. Do not put loose batteries in your pocket, purse, bag or anywhere else. When the battery is not in use, you must store it in a plastic battery case to reduce the risk of a battery explosion.
Always charge in or on a fire-proof surface. Never leave charging batteries unattended.
Do not modify batteries or chargers in any shape or form.
Only use Lithium Ion rechargeable batteries in devices that have a built in protection circuit board(PCB) that detect shorts, over-discharge, over-charging etc. Use of lithium ion batteries without a PCB may increase your risk or explosion and,or fire.
Store your batteries away from the sun and heat to prevent overheating your batteries.
Please be sure to inspect your battery before use to ensure it is not damaged including tears or rips in the battery wrap. Discontinue use immediately if battery is damaged.
Do not discharge batteries below 2.5V. Do not charge the batteries over 4.2V.
myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-Ion battery. Please have a basic understanding of the batteries you are using and how to care for them properly.
|